No, the coil is non-replaceable.
The output mode of the Aspire Vilter 2 is a 3.4V constant output mode.
The Aspire Vilter 2 has a Type-C port and its maximum charging current is 1A.
Yes, the Aspire Vilter 2 is an auto-draw device, just inhale from the drip tip and it will activate the coil automatically.
1) Remove the pod from the device;
2) Pull the bottom silicone seal, fill the e-liquid into the pod directly;
3) Close the silicone seal;
4) Put the pod into groove joint of the device.
The capacity is 900 mAh.
The wire of both 0.8 ohm and 1.0 ohm mesh coil is made of Kanthal AF.
The LED light will flash red 15 times to indicate that you need to charge the Vilter 2.